. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Removal and Replacement Procedures 5-21
5.4.2 Computer Feet
There are four locations where the two different computer feet may be applied. The
locations are: one on the hard drive and three on the CPU base cover. To replace the
computer feet, complete the following steps:
1. Peel the old foot from the computer. Use a razor blade if needed to lift a corner of
the foot free from the base cover.
2. Clean the area where the new foot is to be applied with a clean dry cloth.
3. Install the new foot, pressing it firmly into place.
Figure 5-19
. Computer Feet Locations
To Next Page
Loading...
