. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-22 Removal and Replacement Procedures
5.4.3 Handle
This section describes the removal and replacement of the handle. To remove the
handle, complete the following steps:
To attach the handle to the computer, follow these steps:
1. If a charged battery is installed in the DualBay, initiate Suspend. (If not, initiate
Hibernation by pressing Fn+
suspend.) Close the computer, detach external devices,
then turn the computer bottom side up.
2. Line up the metal tabs on the handle with the slots on the back of the computer.
3.
Attach the handle to the computer.
Figure 5-20.
Attaching the Handle to the Computer
To Next Page
Loading...
