Replacing the Keyboard Assembly
If installing a new keyboard assembly, the hook and loop fastener will
have to be attached to the diskette drive bracket:
To attach the hook and loop fastener to the diskette drive bracket, follow
these steps:
1. Separate the new hook and loop fastener.
2. Attach the opposite color of the hook and loop fastener to the existing
hook and loop fastener on the tab on the diskette drive bracket [1]
(Figure 3-27).
3. Remove the top layer from the hook and loop fastener to expose the
adhesive strip prior to replacing the keyboard assembly [2]
(Figure 3-27).
To Next Page
Loading...
