7. Replace the battery pack and reconnect the AC power.
Chapter 3.14 Diskette Drive (All Models)
This section contains removal and replacement procedures for the following
diskette drive components:
o Diskette Drive
o Diskette Drive Bracket
o Diskette Drive Insulator Strip
Removing the Diskette Drive
To remove the diskette drive, follow these steps:
1. Disconnect all power from the computer and remove the AC Adapter and
battery pack (Section 3.2).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The computer becomes top heavy when the keyboard assembly is removed and
the display is opened. To prevent damage to the display and the computer,
ensure that the display assembly is opened to a 90-degree angle.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
2. Remove the keyboard assembly (Section 3.7).
3. Disconnect the diskette drive cable from the LIF connectors on the
diskette drive and the system board (Figure 3-41).
To Next Page
Loading...
