Desktop Management Guide www.hp.com 9
Desktop Management Guide
3. Turn on the computer.
If no ROMPaq diskette or ROMPaq CD is found, you will be
prompted to insert one and restart the computer.
If a setup password has been established, the Caps Lock light will
turn on and you will be prompted to enter the password.
4. Enter the setup password.
If the system successfully starts from the diskette and
successfully reprograms the ROM, then the three keyboard lights
will turn on. A rising tone series of beeps also signals successful
completion.
5. Remove the diskette or CD and turn the power off.
6. Turn the power on again to restart the computer.
The following table lists the various keyboard light combinations
used by the Boot Block ROM (when a PS/2 keyboard is attached to
the computer), and explains the meaning and action associated with
each combination.
Keyboard Light Combinations Used by Boot Block ROM
FailSafe Boot
Block Mode
Keyboard
LED Color
Keyboard
LED Activity State/Message
Num Lock Green On ROMPaq diskette or ROMPaq CD
not present, is bad, or drive not
ready.
Caps Lock Green On Enter password.
Num, Caps,
Scroll Lock
Green Blink On in
sequence, one at
a time—N, C, SL
Keyboard locked in network mode.
Num, Caps,
Scroll Lock
Green On Boot Block ROM Flash successful.
Turn power off, then on to reboot.
✎
Diagnostic lights do not flash on USB keyboards.
To Next Page
Loading...
Need help?
General
