Getting Connected 7-7
End a Connection
If you started the connection from a program, such as Inbox or Pocket Internet Explorer,
disconnect from that program first. Then, tap then Today. Tap or at the bottom
of the screen then Disconnect. To end a network connection, remove the card from your
iPAQ H3000.
Connect Directly to an E-mail Server
You can set up a connection to an e-mail server so that you can send and receive e-mail
messages by using a modem or network connection and Inbox on your iPAQ H3000.
NOTE: The ISP or network must use a POP3 or IMAP4 e-mail server and an SMTP gateway.
Inbox does not currently support connecting with proprietary e-mail protocols such as
Juno, or Virgin Net. However, you can still access the Internet through these services.
There may be third-party programs available that would enable you to send and receive
e-mail messages through proprietary protocols.
You can use multiple e-mail services to receive your messages. For each e-mail service
you intend to use, first set up and name the e-mail service. If you use the same service to
connect to different mailboxes, set up and name each mailbox connection.
To set up a e-mail service:
1. Tap Services, then New Service in Inbox on your iPAQ H3000.
2. Select POP3 or IMAP4 as the service type, name the service, and tap Next. For infor-
mation on which service type to select, ask your ISP or network administrator.
To Next Page
Loading...
