Care and Maintenance 47
Part Number: 216023-001 - Writer: Carey Gregg - Saved by: The Integrity Group
Pages: 5 Words: 867 Saved date: 09/22/0010:10 AM File Name: Ch05.doc
Follow these steps to replace the projector lamp module:
1.
Turn off the power to the projector by pressing the blue Standby
button ➊.
2. Allow the projector to cool down for at least 30 minutes.
!
WARNING: The lamp assembly operates at a very
high temperature. To reduce the risk of personal injury,
allow the projector to cool down for at least 30 minutes
before opening the lamp cover. Never open the lamp
cover while the projector is operating or when the lamp
is hot.
3. Disconnect the power cord
.
To Next Page
Loading...
