2
E
Compressor cooling box 12 / 24 / 230 V
User manual
Features
ź High efficiency DC inverter compressor and conversion module with high reliability and long life.
ź Fluoride-free insulation with good heat preservation performance and low energy consumption.
ź 12/24VDC and 110~240VAC power supply, allow use in the car or at home.
ź Compressor delay protection
ź Quick cooling to -20℃(based on 25℃ ambient temperature).
ź Intelligent car battery protection system.
ź Wide range electronic temperature control.
Safety instructions
ź Warning: Do not attempt or continue to operate your unit if it is wet. The installation of the DC
power source in the boat should be handled by the qualified personnel.
ź Make sure the voltage is within the correct range for socket and cable being used. The technical
data label on the side of the unit shows the voltage ranges.
ź No electrical devices inside the refrigerator as they may be damaged.
ź During transportation, slope less than 45° and handle carefully.
ź Your unit requires good ventilation, allow the following free space for the air circulation: Back:
200mm Side:100mm
ź The unit must be placed in dry and ventilated place which is far from heat source (such as stove,
flue) and avoid direct sun-shine.
ź It is recommended to operate the unit on a flat surface. Maximum operation angle is 30°.
ź Doubled inner tank allows water filling, but it do not allow pouring out water by inverting the unit.
Let the shell of the unit dry after raining if it get wet. Do not allow to dump the unit in the water.
ź Although the unit has been cleaned before leaving factory, we strongly recommend to use soft
cloth dampened with warm water and a little neutral detergent to clean it again, after that, wipe it
with dry soft cloth.( Warning: Electrical parts can be wiped by dry cloth only)
ź Warning: Do not allow children to play with the refrigerator (such as climbing or standing in the
refrigerator). They could damage the refrigerator and seriously injure themselves.
To Next Page
Loading...