How to fix Power LED if it does not come ON on Compex MicroHub /16 TP1016C Network Router?
If the Power LED on your Compex Network Router doesn't come on, check that the plug/cord is properly inserted into the socket and the hub’s ON/OFF switch is turned ON.
General| Model | TP1016C |
|---|---|
| Switching Capacity | 3.2 Gbps |
| Data Transfer Rate | 100 Mbps |
| MAC Address Table | 8K entries |
| Power Supply | AC 100-240 V |
Details the various LEDs, buttons, and ports on the Compex MicroHub units for installation and operation.
Highlights cost-effectiveness, unmanaged hub capabilities, and network diagnostic aids.
Outlines industry standards, interface types, link distances, and port configurations for the hubs.
Provides physical dimensions, weight, safety certifications, and power supply requirements.
Explains the function of each LED indicator and provides basic troubleshooting steps for hub issues.
To Next Page
