Loading instructions:
1. Disconnect power source.
2. Unlock the magazine by releasing latch in the back, and slid-open the magazine.
Loading staples :
3. Place the tool upside-down, and load staple strip in magazine rail so that the crown of the staple (top flat part) is in the
uppermost of magazine.
4. Push the track back until release latch clicks. (A click sound from the latch indicates it has been locked properly.
7. Operating instructions
1. Turn the power switch in “OFF” position (O).
2. Plug tool into 220-240V~50Hz power outlet.
3. Grip the tool firmly and hold against work piece.
4. Turn the power switch in “ON” position.
5. Press the safety yoke hard enough to activate trigger.
6. If necessary, place palm of free hand on top of the tool to achieve better penetration.
7. Always disconnect the tacker from the power supply after use.
8. Clearance of jamming
In the event of malfunctions caused by jammed staples or nails proceed as follows：
1. Disconnect main plug.
2. Release latch and slide open the magazine.
3. Grab jammed fasteners with pliers and remove.
9. Maintenance
Disconnect main plug and unload the magazine.
Clean the magazine space, guide plate and other active parts with a jet of compressed air.
It is recommended to put one drop of machine oil on the driver slide area. Do not lubricate the internal parts of the tacker.
Never use solvent or other liquids in cleaning this tool.
Do not use or keep the tacker in wet or dusty locations.
Do not disassemble or alter the tacker. All defective or non-working machines should be repaired only by fully trained technician.
To Next Page
Loading...
