Compliance Products USA, Inc
CAL-Fac-001-MP-CDT 240 Rev 2.3 Page 1 of 13
1.0 TITLE
Calibration procedure for CDT-240.
2.0 PURPOSE
To describe the CDT-240 calibration procedure.
3.0 DEFINITIONS
DMM - Digital Multimeter
CAL-BOX - Calibration Box (00-CDT-CBX)
4.0 PRECAUTIONS
4.1 The CDT-240 tester is capable of generating high voltage. Be very careful to follow all
directions in the procedure.
5.0 MATERIALS/EQUIPMENT NEEDED
5.1 Calibrated DMM (Qty 2) DMM1 for voltage RMS below 50V and the DMM2 for
voltages RMS 50V or greater.
5.2 Calibrated Oscilloscope ( with 10x or 100x probe )
5.3 DC power supply 60V
5.4 BNC cable, 1:1 ratio
5.5 Screwdrivers
6.0 PROCEDURE
6.1 Once a technician has been trained on this procedure by an appropriate person, follow the
directions listed in Appendix 1.
6.2 An appropriate person shall be any technician that has performed the calibration of a
CDT-240 tester and can explain the procedure and safety concerns.
7.0 APPENDICES
7.1 Appendix 1 CDT-240 Factory Calibration Procedure.
8.0 RELATED ITEMS
8.1 CAL-Log-001-CDT 240
8.2 CBX1V Video
To Next Page
Need help?
General
