Compulite Vector Violet - Page 81

75
VECTOR
PROGRAMMING AND UPDATING CUES
To set fade times when programming a cue
Example: Add fade times when programming QList 1 cue 5.
1. Select fixtures and set values.
2. Select QList 1 and cue 5.
3. Press
TIME.
The
Editor tool bar is now in time mode.
4. To set time-in, press
4.5 on the numeric keypad.
5. Press
DELAY IN and 3 on the numeric keypad.
6. Press
DELAY OUT and 2 on the numeric keypad.
7. Press
STORE.
To set fade times when programming a cue
Example: Add fade times when programming QList 1 cue 5.
1. Select fixtures and set values.
2. Press
ENTER.
3. Press
STORE.
4. Select QList 1 and cue 5.
5. Press
TIME.
The
Editor tool bar is now in time mode.
6. To set time-in, press
4.5 on the numeric keypad.
7. Press
DELAY IN and 3 on the numeric keypad.
8. Press
DELAY OUT and 2 on the numeric keypad.
9. Press
ENTER.
Time: Time in Time out Delay in Delay out Wait
Set to:
4.5 Default (4.5) 3.0 2.0 Manual
Time: Time in Time out Delay in Delay out Wait
Set to:
4.5 Default (4.5) 3.0 2.0 Manual