Manual of Instructions
for X-KEY Key-safe
ATTENTION: Please read the operating instructions
carefully, before you operate the lock or try to
program a new combination of numbers. We canot
accept any liability for problems caused by not fol-
lowing the set up intructions correctly
Please note that your X-KEY-safe
is delivered with the factory-set
code 0 – 0 – 0
and for security reasons, you now need set your
own personalised code.
1. OPENING FOR FIRST TIME
1.1. Remove the plastic cover from the lock.
1.2. Turn the combination lock until the factory-
set code 0 – 0 – 0 is level with the opening
marks.
1.3. Turn the combination lock to the LEFT.
1.4. Turn the opening handle to the RIGHT all the
way until it stops.
1.5. The safe door is now open.
2. SETTING A YOUR NEW CODE
2.1. Select your new three-figure code
2.2. Use a pen on blunt object to push and hold
down the reset button, which I can be found
within the recess hole found at the side of the
combination lock. Hold it pushed down until
the re set process is completed.
2.3. Now turn the number wheels until your new
three-figure code is level to the open marks.
2.4. Now release the reset button.
2.5. Your new code is now set .
2.6. IMPORTANT:
please check your new code
works a few times with the safe door open.
3. OPENING THE X-KEY safe
3.1. Turn the combination lock until the code
numbers are level to the open marks.
3.2. Turn the combination lock left.
3.3. Turn the opening handle to the right until it
stops.
3.4. Safe door is now open.
4. LOCKING THE X-KEY Key-safe
4.1. Close the door and turn the rotating handle to
the left.
4.2. Turn the combination lock to right until it
stops.
4.3. Scramble the number combination.
4.4. Your X-KEY safe is now locked.
4.5. Double check the door is locked.
X-KEY Key-safe 5
Attention:
Your new Safe and it’s content aren’t
automatically insured.
Please write a letter to your
insurance about the insurance value
you’d like.
GB
USA
ENGLISH
To Next Page
Loading...
