Comtek PR-216 - Specifications

PR-216 SPECIFICATIONS
Page 12
Audio Output:
Headset output +16 dBu
(low impedance)
Connector:
3.5 mm stereo/mono input used for:
Headphone cord antenna to receiver
Audio output to headphone
Battery charger input
Auxiliary power input
Indicators:
Three function LED
Power
Battery status
R.F. signal ON and OFF
Controls:
Power On/Off switch
Volume control (50 dB range)
EnviroMic ON/OFF switch (optional)
99-position rotary channel
selector switches
Audio Frequency Response:
80 Hz to 12 kHz ±3 dB
Harmonic Distortion:
Less than 1% (1 kHz tone 5 kHz
deviation)
Operating Radio Frequency:
216 to 217 MHz
Frequency synthesized
Frequency Stability:
0.002% frequency synthesized
crystal controlled
•
•
•
•
•
•
RF Sensitivity:RF Sensitivity:
0.3 µV for 12 dB SINAD
Adjacent Channel Rejection:
65 dB 50 kHz off channel
Spurious Rejection:
60 dB (image excluded)
Ultimate Quieting:
Better than 95 dB
Deviation Acceptance:
Up to 10 kHz
Antenna:
Integral with output cable
(no external antenna)
Current Drain:
18 mA nominal
Power Requirements:
9 volt alkaline battery,
Eveready 522 or equivalent
or 9 volt Ni-MH rechargeable
FCC Compliance:
Complies with Part 15
of FCC rules
Dimensions:
1
1
/16" x 2
1
/2" x 3
1
/4"
(27 mm x 57 mm x 83 mm)
NOTE: Specifications subject to
change without notice
•
•
•
•
•
•
•