To Next PageTo Next Page
Need help?Do you have a question about the Comutech 100601 and is the answer not in the manual?
General| Brand | Comutech |
|---|---|
| Model | 100601 |
| Category | Battery Charger |
| Language | English |
Identifies wire colors: Blue for Neutral, Brown for Live, Green/Yellow for Earth.
Inspect wiring regularly and keep cords clear of hazards to prevent damage or shock.
Manual contains important safety and operating instructions for the battery charger.
Avoid exposing the charger to rain or snow to prevent hazards.
Use only manufacturer-approved attachments to prevent risks of fire, shock, or injury.
Disconnect by pulling the plug, not the cord, to prevent damage to the electric plug and cord.
Ensure extension cords are compatible, properly wired, and in good electrical condition.
Replace damaged cords or plugs immediately to ensure safe operation.
Lead-acid batteries generate explosive gases; read and follow all instructions carefully.
Ensure ventilation, have water/soap nearby, wear eye protection, and avoid sparks/metal tools.
Use charger for lead-acid batteries only; do not charge dry-cell batteries.
Remove grounded terminal first if battery is removed; ensure area is well-ventilated.
Clean terminals, add distilled water carefully, and follow manufacturer instructions.
Locate charger away from battery, avoid placing directly above, and ensure ventilation.
Connect/disconnect clips after removing AC cord; avoid touching clips together.
Check polarity, determine grounding, and connect clips to correct battery posts or chassis.
Check polarity and connect clips to battery posts, keeping ends away from battery.
Maintain labels, wear eye goggles and gloves for protection.
Maintain a safe, well-lit work area; avoid flammable areas and wet locations.
Unplug before connecting, keep cords dry, use only with lead/acid batteries, avoid overcharging.
Do not charge non-rechargeable batteries, charge multiple batteries simultaneously, or discard batteries improperly.
Product may contain chemicals causing harm; consult physician if using a pacemaker.
If gas is detected, ventilate immediately, do not switch on fans, and unplug unit.
For 12V lead-acid batteries, 10-60Ah capacity, AC230V input, 2.8A charge current.
Connect red clip to positive, black clip to negative, plug into 220vlt power source.
Operate from AC 230V, avoid short circuits, place in dry/ventilated location, indoor use only.
Features float charging, reverse connect, short-circuit, thermal fuse, over-charged protection, LED indicators.
Includes 1.7M power cable with plug and 1.4M output cable with clips.
