MT series remote control intelligent turntable user guide
Copyright reserved by Shenzhen ComXim Technology Co., Ltd. 2017
11
Figure13 Turntable X Interface detail
The steps of using software to control the operation of the turntable are very simple：
First Step : Turn on the software connection carousel (the type of connection selected according to the way the
turntable is supported is IPv4 or COM)
Second Step :Set the rotation mode and the corresponding parameters in the mode selection section（Or press
the shortcut key automatic intermittent setting parameters, such as press the number "36", the software will
automatically set the parameters for a circle divided into 36 times, to stop the batch mode rotation 10 degrees,
pause 4 seconds, repeat 36 times, note: <10 *36 = > 360 times）
Third Step : Start the turntable in the functional operation section，For example, you want to turn left or right
by the parameters set in 2. Just press the left turn or the right turn.
To Next Page
Loading...