MT series remote control intelligent turntable user guide
Copyright reserved by Shenzhen ComXim Technology Co., Ltd. 2017
14
7 Other Instructions
After electricity, the test program of the turntable will run automatically(it usually takes 3-9 seconds).If the
buzzer keep beeping or make intermittent sounds continuously, the test failed then, since the ringing of
buzzer should be three times. Then, you had better plug it again.
While using the controller (infrared remote control, mobile phone App, Windows PC) to control the
turntable, the turntable buzzer will make corresponding tweets, prompting the user to receive control
command:
1) If the turntable receives the button command correctly, the buzzer will beep 1 or 2 times based on the
state of the keys.
2) If the buzzer does not beep after the button, the button information is not received correctly, or the
turntable does not support that function.
3) Buzzer of MTxxxxSL and other more professional mode will beep for two times, before the automatic
shutter signal is sent out.
Instructions of turntable indicator
power light
Indicator shows if the
turntable is connected
via USB
Before electricity: lights out.
After electricity:
The start and lose of heart heartbeat: lights out.
Hearts beat normally when start, or stop heartbeat:
lights on.
Before electricity: lights out.
After electricity: lights on.
To Next Page
Loading...