OPERATING
INSTRUCTIONS
1. Plug the unit into the electrical outlet.
2. Release lever will light up. Allow one or two
minutes for the unit to warm up. The appliance
is ready to use when release lever light is off.
3. Holding the steam jets away from you and
anyone else in the room, engage the trig-
ger. Steam should now be released from the
steam jets.
4. When first using the device, test on an old
cloth, as there may be sediment left from the
manufacturing process or transportation.
5. To stop the flow of steam, release the trigger.
6. Unplug the device when it is not in use.
STEAMING TIPS
1. To prepare your fabric for steaming, brush
it with the fabric/lint brush attachment. This
will loosen the fibers and allow better steam
penetration.
2. Hang your garment or fabric.
3. Pass the steam jets just above the fabric
where the wrinkles are. It may take a few
passes to remove the wrinkles completely.
4. After use, unplug steamer and empty any
remaining water from the tank to avoid leakage.
ADDITIONAL
INFORMATION
FOR DUAL-VOLTAGE
PRODUCTS
For use in the U.S.A., the voltage selector
switch should be placed in the 120 position.
For use in several countries overseas, the
voltage selector may need to be placed in the
240 position. Confirm the voltage available
at each overseas location before using the
appliance. For connection to a 240 volt supply,
use an attachment plug adapter of the proper
configuration for the power supply receptacle.
For 120 Volt Operation
Flick the dual voltage switch to the 120
position.
For 240 Volt Operation
Flick the dual voltage switch to the 240
position. A plug adapter may be necessary
in certain countries..
To Next Page
Loading...
Need help?
General
