Name: concept 2 BikeErg
Brand: concept 2
Rating: 4 (1 reviews)

To Next Page

Page 1 0119

BikeErg Box Frame with Flywheel Replacement

Materials Needed

• T27 6-lobe driver*

• 6 mm hex L-key*

*Included with BikeErg

Procedure Overview

• Remove generator and unplug wires

• Remove pedals, front and rear legs

• Install new box frame with ﬂywheel

• Connect generator and tighten all fasteners

1. The generator is the tapered black plastic housing

that sits against the ﬂywheel and directly behind

the front post. Note how the two wires exit the

housing through small reliefs in the edge. Using

the T27 6-lobe driver, remove the two screws that

hold the generator to the top of the frame.

2. Turn the generator over and unplug the cable that

connects the PM5 monitor to it. Reinstall generator

with the cable disconnected. The cable can be

temporarily wrapped around the handlebars and

out of way.

3. Using the 6 mm hex L-key remove BOTH pedals

from the crank arms. Note that the pedal stamped

with R (right) is loosened by turning counter

clockwise; the pedal stamped with L (left) is

loosened by turning clockwise.

Procedure

Right Side

Other manuals for concept 2 BikeErg

Questions and Answers:

Need help?

Do you have a question about the concept 2 BikeErg and is the answer not in the manual?

General