Conceptronic C54APM - Page 53

ENGLISH
53
nfiguration To
se the "Backup" tool to save s Point’s current configuration to a file named
3.2.7. Co ol
the AccesU
"config.bin" on an use the "Restore" tool to upload and restore the saved
configuration to int. Alternatively, you can use the "Restore to Factory
ss Point to perform a power reset and restore the original
your PC. You c
the Access Po
efault" tool to force the Acce
D
factory settings.
Click the Apply button at the ottom of the screen to save the above configurations. b
ware Upgrad
d
3.2.8. Firm e
This tool allows you to upgra e the Access Point’s system firmware. To upgrade the firmware
of your Access Point, you need to
file
rocess is complete.
download the firmware file to your local hard disk, and enter
the file name and path in the appropriate field on this page. You can also use the Browse
button to find the firmware on your PC. Please reset the Access Point when the upgrade
p
Click the Apply button at the ottom of the screen to save the above configurations. b
et
the system st you
3.2.9. Res
In the event that ops responding correctly or in some way stops functioning,
can perform a re tings will not be changed. To perform the reset, click on the
Apply button. d to confirm your decision. Once the reset process is complete
s Point again.
set. Your set
You will be aske
you may start using the Acces
Click the Apply button at the bottom of the screen to save the above configurations.