Conceptronic CPNP200P - Device explanation; Component identification; LED status indicators

ENGLISH
5
2. Device explanation
Nr
Description
A.

With the „Pair‟ button, you can create a secured Powerline network.
B.

The „AP‟ LED indicates if a Powerline adapter is configured as main Access Point
(AP) adapter, or if a network setup is in progress.
C.
-
The „P-Link‟ LED indicates if a Powerline network is established and shows the
signal quality.
D.
-
The „E-Link‟ LED indicates if the LAN port is in use.
LED
Status
Explanation
AP
Off
The Powerline adapter is not set as Access Point.
On - Steady
The Powerline adapter is set as Access Point.
On  Flashing
The Powerline adapter is accepting connections for a secured
Powerline network.
P-Link
Off
The Powerline adapter is in Standby mode.
On - Red
No Powerline network or bad Powerline signal quality.
On - Green
A Powerline network is active with good signal quality.
On - Flashing
Data is send /received through the Powerline network.
E-Link
Off
No LAN connection.
On  Green
The LAN connection is active.
On - Flashing
Data is send / received through the LAN connection.