CONDOR
®
SCC-4000 FLOOR ADAPTOR (SCFA) USER INSTRUCTION MANUAL
STOP! WARNING: READ THIS FIRST!
First Read and Understand the Instruction manual and product labels for important safety, set-up and troubleshooting information. If you have problems setting up or
using the Condor® Scooter Chock Floor Adaptor, contact customer service @ 1-815-754-7418 or contact us via e-mail @ www.condor-lift.com. The Condor®
Scooter Chock Floor Adaptor is not intended for use by children.
Assembly Instructions
:
Remove all parts from shipping box. Check the parts below to make sure you have all the parts needed to assemble your Condor®
Scooter Chock Floor Adaptor before beginning. In the unlikely event that you find a part damaged or missing, please call customer service @ #1-815-754-7418.
Parts Key Qty. Description
A 2
Condor® Boomerang Bar
(SC-VSTRIP-C)
B 4
5/16”-18 X ½” Button Head Cap Screw
(WSL-94067)
Assembly Illustration:
Figure 1
Warning: Only use unit when
properly assembled.
Step1: Remove Front Stop assembly by taking out
the two ½” pins in the front of the unit.
Step2: Align inside holes of the Boomerang Bar (A)
with the holes on the ends of the base as shown in
the Figure2.
Step3: Secure the Boomerang Bar with the provided
Button head cap screws (B) and tighten completely
with the supplied hex key. (Figure1)
Step4: Re-attached Front Stop assembly and place
the unit on a flat, clean surface.
Figure 2
To Next Page
Need help?
General
