Connect CM Series - User Manual

Ashley LozanoJul 30, 2025

What to do if the Connect Industrial Equipment magnet is not picking up debris?

J
John PerezJul 30, 2025
If the voltage at the input of the electronic controller is 180V AC, replace the controller box. If the voltage is between 150V and 250V, check the coil continuity. If the voltage is greater than 250V, replace the IGBT. If the generator voltage is greater than 180V AC (with the controller box disconnected from the generator), replace the controller box. Also, improve hydraulic parameters.

Summary

Safety Information

Safety Statements and Hazard Alerts

Information about safety statements and hazard alerts in the manual.

Purpose of Safety Messages

Explains the purpose of safety messages and information.

Key Points Before Operating Equipment

Key points to consider before operating the equipment.

Signal Words

Explains safety symbols and signal words used in the manual.

Signal Words Used for Non-Hazard Messages

Describes signal words IMPORTANT and NOTE for non-hazard messages.

Safety, Information and Identification Labels

Discusses safety, information, and identification labels on the equipment.

Meaning of Pictograms

Explains pictograms used for rapid communication of information.

Attention Read the Manual

Emphasizes reading the manual for safe operation and maintenance.

General Construction Safety

General safety procedures for construction environments.

Owners Responsibilities

Outlines the responsibilities of the equipment owner.

Personal Protective Equipment (PPE)

Details necessary personal protective equipment for operators.

Protective Equipment - Guarding

Discusses the importance and use of protective guards on equipment.

Unapproved Modifications

Warns against unapproved modifications and their consequences.

General Information

Introduction

Provides an introduction to the Connect Work Tools Magnet manual.

Safety Precautions

Outlines essential safety precautions for operating the magnet.

Specifications

Magnet Specifications

Details technical specifications for the CM Series Magnets.

Magnet Layout

Illustrates the physical layout of the magnet.

Characteristics

Lists key characteristics of the CM Series Magnets.

Installation

Mounting and Dismounting

Step-by-step instructions for mounting and dismounting the magnet.

Safety Precautions & Operating Instructions

Noise

Information regarding noise levels produced by the hydraulic magnet generator.

Vibrations

Discusses vibrations generated by the hydraulic generator.

Electromagnetical Compatibility - Effects on Workers

Explains effects of magnetic fields on workers and precautions.

Safe Use

Provides guidelines for the safe use of the magnet.

Operation

Step-by-step instructions for operating the magnet.

Inspection and Maintenance

Cleaning the Hydraulic Magnet

Procedures for cleaning the hydraulic magnet.

Routine Maintenance

Details routine maintenance tasks and schedules for the magnet.

Repairing Faults Inspection

Guide for diagnosing and repairing faults in the hydraulic magnet.

Assembling

Provides torque specifications for assembling metric fasteners.

Normal Inspection

Lists checks for normal operation and pre-use inspection.

Maintenance Schedule

Outlines a schedule for daily, weekly, and annual maintenance tasks.

Troubleshooting

Troubleshooting Chart

A chart to diagnose and resolve common problems with the magnet.

Equipment Identification

Location of the Serial Number Decal

Shows the location of the serial number decal on the magnet.

Owners Record of the Equipment

Section for recording equipment model and serial number for owner's records.

CM Series Magnets Limited Warranty

Standard Rate Schedule

Details the standard rate schedule for warranty evaluation and processing.

Warranty Coverage

Specifies the warranty coverage periods for parts and labor.

Brand	Connect
Model	CM Series
Category	Industrial Equipment
Language	English

Brand

Connect

Model

CM Series