Connect Plantronics - User Manual

Plantronics Wireless Headset Installation Guide
F o r S e r v i c e C a l l : ( 8 0 0 ) 5 9 5 - 8 8 8 2 / E m a i l : d i s p a t c h @ o k t e l e p h o n e . c o m
Page 1
Take the AC Power Supply adapter and plug one end into your wall outlet or power strip. The
other end will plug into the back of the headset base, as shown in the following picture. Place
the headset into the base. You will feel a snug pull when the two magnets pull ensuring a
perfect fit. The charging LED will flash green when charging and turn solid green when fully
charged. They will vary in time, fully charge prior to set up. After that, put on charger when
not using. Battery will beep when it is getting low.
If not using a
handset lifter
toggle this switch
to the right so
that headset
turns on
automatically
when taken out
of base
Basic Set Up:
Flashing Green = Charging
Solid Green = Fully Charged
Locate the Telephone Interface Cable. It will have plastic modular plugs on each end
and a black connector in the middle of the cable. Take the larger modular plug and
insert it into the base that shows a picture of a telephone.
Plug the Telephone Interface Cable into the headset port (usually located on the bottom
of the phone)
You will have to program a headset Key on your phone using this option. To program a headset
button, without lifting the handset, press SPEAKER, Enter 751, Touch the key you are going to
program, enter 05, press SPEAKER. A headset key is not required when using a handset lifter.

Summary

Basic Setup

AC Power & Base Connection

Connects AC power to headset base and places headset for charging, noting LED indicators.

Telephone Interface Cable

Connects the telephone interface cable between the headset base and the phone.

Headset Key Programming

Instructions for programming a headset button via phone keypad for headset use.

Handset Lifter Setup

Lifter Cable & Connection

Connects telephone interface cable and attaches the HL10 handset lifter to the phone.

Lifter Operation & Call Handling

Explains how the handset lifter detects ringing and how to answer/hang up calls.

EHS Cable Setup

EHS Cable Connection

Connects the Electronic Hookswitch (EHS) cable between the headset base and the phone's headset port.

EHS Functionality Note

Notes that a technician must program the phone for the EHS cable to function.

Wireless Headset Functionality

Headset Controls & Indicators

Details the headset's call control, volume adjustment, mute function, and LED indicator.

Understanding Headset Base Controls

Speaker & Microphone Volume

Explains adjustment of speaker volume for hearing and microphone volume for callers.

Compatibility Slide Switch

Details the function of the compatibility slide switch for phone compatibility.

Connect Plantronics Specifications

General

Model	Plantronics Voyager 5200
Connectivity	Bluetooth
Battery Life	7 hours talk time, 9 days standby
Range	Up to 30 meters/98 feet
Compatibility	Bluetooth-enabled devices