EMAIL:
customercare@conquerequipment.com
Trainer Setup for 26”
, 27” & 700C wheeled bikes w/
*Review and follow
instructions prior to each use, and keep
*Use the product
only as described in this manual.
*Before each use, inspect the trainer and bicycle to ensure safety.
*Refer to the documentation for any questions. If you are unsure of use or have warranty
inquiries, please visit ConquerEquipment.com
1. Remove all packaging, unfold the frame, and place on a level floor.
2. Replace your bicycle’s rear wheel quick
your trainer. This is to make your bike fit the trainer properly, for stability and for safety.
IMPORTANT: Before placing your bike in the trainer, rotate the right side hub
and release the wing nut A or adjust the wing nut B on the left side to create a wide
enough clearance in between the couplings.
3. Install the bike’s rear hub between th
the rear hub. Then adjust wing nut B to lock against the trainer. DO NOT
OVERTIGHTEN.
Product name:
Conquer Indoor Bike Trainer
SKU: 530-TRAINER
EMAIL:
customercare@conquerequipment.com
TEL: 855-349-4327
help.ConquerEquipment.com
customercare@conquerequipment.com
WEB: help.conquerequipment.com
, 27” & 700C wheeled bikes w/
instructions prior to each use, and keep
with
trainer for future reference.
only as described in this manual.
*Before each use, inspect the trainer and bicycle to ensure safety.
*Refer to the documentation for any questions. If you are unsure of use or have warranty
inquiries, please visit ConquerEquipment.com
1. Remove all packaging, unfold the frame, and place on a level floor.
2. Replace your bicycle’s rear wheel quick
-
release skewer with the skewer included with
your trainer. This is to make your bike fit the trainer properly, for stability and for safety.
IMPORTANT: Before placing your bike in the trainer, rotate the right side hub
and release the wing nut A or adjust the wing nut B on the left side to create a wide
enough clearance in between the couplings.
3. Install the bike’s rear hub between th
e couplings, and adjust wing nuts C and A to lock
the rear hub. Then adjust wing nut B to lock against the trainer. DO NOT
Conquer Indoor Bike Trainer
customercare@conquerequipment.com
855-349-4327
Wheels
trainer for future reference.
*Refer to the documentation for any questions. If you are unsure of use or have warranty
release skewer with the skewer included with
your trainer. This is to make your bike fit the trainer properly, for stability and for safety.
IMPORTANT: Before placing your bike in the trainer, rotate the right side hub
-clamp D
and release the wing nut A or adjust the wing nut B on the left side to create a wide
e couplings, and adjust wing nuts C and A to lock
To Next Page
Need help?
General