Need help?Do you have a question about the Conrad-johnson design MV60 and is the answer not in the manual?
General| Power Output | 60 Watts per channel |
|---|---|
| Number of Channels | 2 |
| Input Impedance | 100 kOhms |
| Output Impedance | 4, 8, 16 Ohms |
| Gain | 26dB |
| Type | Vacuum Tube Amplifier |
| Frequency Response | 20Hz to 20kHz |
| Total Harmonic Distortion | 1% |
| Signal to Noise Ratio | 90 dB |
| Dimensions | 17.5 x 7.5 x 15.5 inches |
Details items not covered by the limited warranty, including misuse, unauthorized modifications, and normal wear.
Outlines the procedure for shipping the unit for warranty service, including packing and shipping requirements.
Details required ventilation, mounting surfaces, and clearance for heat dissipation.
Describes connecting the preamplifier to the MV60 via RCA connectors on the back.
Details the procedure for adjusting output tube bias after replacement or periodically.
To Next Page
