37
To avoid distortion or mismatching which could damage the amplifi-
er or the subsequent component, only devices with cinch inputs
may be connected to the cinch outputs.
Connect the connection OUTPUT (8)
with the input of the subsequent com-
ponent.
Operation
Active Duplexer
Model XCA 1200/1600
The amplifier is provided with an active duplexer which allows to switch a high-pass
or a low-pass branch for the rear channels. One high-pass branch is provided for the
front channels.
The cut-off frequencies can be continuously adjusted.
Model XCA 700
The amplifier is provided with an active duplexer which allows to switch a high-pass
or low-pass branch for the two channels.
The cut-off frequencies can be continuously adjusted.
The frequency duplexer switch (4) sets
the operating mode of the active
duplexer.
white cinch jacket (L)
> input left
red cinch jacket (R)
> input right
FULL:
Active duplexer switched off, the
amplifier branch plays back the com-
plete frequency range
HP:
High-pass duplexer switched on, the
amplifier branch only plays back the
frequency range above the frequency
set via the HIGH PASS (1) control unit.
LP:
Low-pass duplexer switched on, the
amplifier branch only plays back the
frequency range below the frequency
set via the LOW PASS control unit (2).
To Next Page
Loading...