Need help?Do you have a question about the Consilium Salwico CS3000 and is the answer not in the manual?
Describes the physical layout and components of the control unit's panel.
Describes the system's indication when a fire alarm is detected.
Details the system's response when multiple fire alarms are present.
Provides instructions for acknowledging and muting fire alarms.
Details the procedure for resetting a fire alarm.
Describes the system's indication when a fault is detected.
Instructions for acknowledging and muting system faults.
Details the procedure for resetting system faults.
Procedure to turn off the alarm delay function.
Procedure to turn on the alarm delay function.
How to change access levels and modify access codes.
Procedures for setting the system's date and time.
How to adjust the sensitivity of smoke detectors.
How to set or change the time delay for smoke detector alarms.
Lists fault codes related to major computer failures.
Lists fault codes for section units, communication errors, and boot issues.
Lists fault codes for addressing, loop issues, definitions, and power faults.
Lists fault codes for detector issues, cable breaks, and short circuits.
Lists fault codes for door/damper issues, power failures, and timer faults.
Explains troubleshooting for cable breaks, short circuits, and power faults.
General| Type | Fire Alarm Control Panel |
|---|---|
| Category | Security System |
| Power Supply | 24V DC |
| Number of Detectors/Call Points per Loop | 126 |
| Number of Devices per Loop | 126 |
| Display | LCD |
| Redundancy | Optional |
| Input Voltage | 230V AC |
| Battery Backup | Yes |
| Communication Protocol | RS485, Ethernet |
| Certifications | EN54 |
| Operating Temperature | 0°C to +50°C |
| Humidity Range | 10% to 95% RH (non-condensing) |
| Networking | Supports network interconnection |
To Next Page
