6 Guttman Boulevard, Charleroi Industrial Park, Charleroi Pennsylvania 15022
(800) 487-8450; Fax: (724) 489-9772 Page 16 of 17 http://www.conspec-controls.com
HAZARDOUS/CLASSIFIED AREA CX SERIES
*WARNING: Remove power or declassify area before opening the sensor housing.
The Hazardous/Classified Area CX Series sensor housing is opened by loosening the Allen screw and
unthreading sensor housing part B from part A.
The replaceable cell can be removed by unplugging the cell from the cell holder card.
Plug the new cell into the cell holder card and rethread sensor housing part B then retighten the Allen screw.
Contaminant/Small particulates Effects:
Dust, coal fines, and rust are all small particulates that are encountered often within industrial environments.
If preventative measures are not taken, these contaminants will likely block the flow of target gas into the
sensor chamber. Once blocked, it can be nearly impossible to clean some sensor housings, and the housing
may need to be entirely replaced. Preventive measures should be taken to avoid the sintered metal filter
from becoming clogged. Available options include PTFE Hydrophobic disc filters to prevent moisture, rust
and build up of small particulates.
To Next Page
Loading...