6 Guttman Boulevard, Charleroi Industrial Park, Charleroi Pennsylvania 15022
(800) 487-8450; Fax: (724) 489-9772 Page 8 of 17 http://www.conspec-controls.com
Communication Settings:
Trunk Address, Parity, and Baud are read from the 900732 Universal Remote Sensor (URS) during power-
on initialization. These parameters are entered into the URS via the Command Code 130 entry method
found on page 8. Following parameter modification, a power cycle must take place for the new settings
to take effect. Default values are address = 1, parity = even, baud = 4800.
0 - None
1 - Even
2 – Odd
0 - 1200
1 - 4800
2 – 9600
3 - 19200
5.0 911118 INFRARED KEYPAD ENCODER
The Universal Transmitter Card is configured using the 911118 Infrared Keypad Encoder (not
included). Command Codes consist of a number followed by the “ENTER” key labeled ‘E’. Entries
can be cleared by pressing the “CLEAR” key labeled ‘C’.
Keys ‘1’ and ‘2’ can also be used to increment/decrement by
a value of 1.
The 91118 Infrared Keypad Encoder uses (3) three ‘N’ size
1.5V batteries. Remove (2) two Phillips head screws on rear
of the encoder to replace.
911118 Infrared Keypad Encoder (not included)
To Next Page
Loading...