CONSTRUCTA CD30637 - Page 24

en Installation instructions
24
WARNING‒Risk of fire!
¡ Grease deposits in the grease filter may
catch fire.
▶
The specified safety clearances must
be complied with in order to prevent a
build-up of heat.
▶
Observe the specifications for your
cooking appliance. If gas and electric
hobs are being operated together, the
largest specified clearance applies.
▶
The appliance must be installed with
no more than one side directly next to
a high-sided unit or a wall. The dis-
tance between the appliance and wall
or high-sided unit must be at least
50mm.
¡ Grease deposits in the grease filter may
catch fire.
▶
Never work with naked flames close to
the appliance (e.g. flambéing).
▶
Do not install the appliance near a
heat-producing appliance for solid fuel
(e.g. wood or coal) unless a closed,
non-removable cover is available.
There must be no flying sparks.
WARNING‒Risk of injury!
¡ Components inside the appliance may
have sharp edges.
▶
Wear protective gloves.
¡ The appliance may fall down if it has not
been properly fastened in place.
▶
All fastening components must be fixed
firmly and securely in place.
¡ The appliance is heavy.
▶
To move the appliance, twopeople are
required.
▶
Use only suitable tools and equipment.
¡ Changes to the electrical or mechanical
assembly are dangerous and may lead to
malfunctions.
▶
Do not make any changes to the elec-
trical or mechanical assembly.
WARNING‒Risk of electric shock!
¡ Sharp-edged components inside the ap-
pliance may damage the connecting
cable.
▶
Do not kink or trap the connecting
cable.
¡ If the appliance or the power cord is dam-
aged, this is dangerous.
▶
Never operate a damaged appliance.
▶
Never pull on the power cord to unplug
the appliance. Always unplug the appli-
ance at the mains.
▶
If the appliance or the power cord is
damaged, immediately unplug the
power cord or switch off the fuse in the
fuse box.
▶
"Call Customer Service." →Seite21
▶
Repairs to the appliance should only
be carried out by trained specialist
staff.
¡ Incorrect repairs are dangerous.
▶
Repairs to the appliance should only
be carried out by trained specialist
staff.
▶
Only use genuine spare parts when re-
pairing the appliance.
▶
If the power cord of this appliance is
damaged, it must be replaced by the
manufacturer, the manufacturer's Cus-
tomer Service or a similarly qualified
person in order to prevent any risk.
¡ Improper installation is dangerous.
▶
Connect and operate the appliance
only in accordance with the specifica-
tions on the rating plate.
▶
Connect the appliance to a power sup-
ply with alternating current only via a
properly installed socket with earthing.
▶
The protective conductor system of the
domestic electrical installation must be
properly installed.
▶
Never equip the appliance with an ex-
ternal switching device, e.g. a timer or
remote control.
▶
When the appliance is installed, the
mains plug of the power cord must be
freely accessible. If free access is not
possible, an all-pole isolating switch
must be installed in the permanent
electrical installation according to the
conditions of Overvoltage Category III
and according to the installation regula-
tions.
▶
When installing the appliance, check
that the power cable is not trapped or
damaged.
Information on the installation situation
¡ Install this appliance in a kitchen cupboard.