1) In device off state, pressing the button could turn on the device,and the device performs self-test, after
self-test is completed, it enters startup interface and makes a beep sound, if self-test fails,itprompts for
failure on the screen.
2) In device on state, short press the button to start measuring.
3) In device on state, long press the button to enter review interface.
4) In review interface, long press the button to enter parameter setting interface. In the setting interface,
short press button to switch items,when the cursor moves to the item to be set, long press the button to
make it under selected state, then short press button to adjust its parameter. After setting the parameters,
long press the button to save and exit.
Parameters in the following can be set
① Sound prompt
② Unit: ℃ and ℉
③ Mode: User can switch the mode to"Obj"(calibration mode). This setting will not be saved, the device
automatically enters"Body "mode after restart.
Note: The body temperature is different from the temperature. In "Body" mode, the device measures the
uman body temperature, and in "Object"mode, it measures the skin temperature. Please be sure to select
the"Body mode when measuring body temperature.
BUTTON AND
PARAMETER SETTING
To Next Page
Loading...
Need help?
General