Contech ScareCrow User Manual

9v
OPEN
4 4
0
5 5
CRO-200
RESET/OFF
5
Aim the Scarecrow towards the area you
want to protect. Push the spike into the
ground by stepping on the footrest.
Place your hands on the sensor housing
to guide and adjust the Scarecrow's
direction.
5. Connect hose and position the Scarecrow(s).
Do not push on the sensor housing
or sprinkler head. If the ground is too
hard or otherwise unsuitable for the
plastic stake, order the CRO-200 Scarecrow
Universal Mounting Bracket.
These fittings should only be hand-tightened.
4. Attach sprinkler head and stake to housing.
5 5
CRO-200
multiple connections
RESET/OFF
Sensitivity Knob
First, turn the sensitivity knob to 4 or 5.
Next, wave your hand in front of the sensor
lens. You should easily hear the Scarecrow's
internal water valve 'click' open, then 'click'
closed 3 seconds later. There is an 8-second
'reset' interval after the valve closes when
the sensor does not detect motion.
3. Check Scarecrow operation. (Dry test)
5
If you hear no "clicking", try a new battery. If the problem persists, call the
factory toll-free at 800-767-8658 for assistance or email support@scatmat.com.
5 5
3. Check ScareCrow operation. (Dry test).
First, turn the sensitivity knob to 4 or 5.
Next, wave your hand in front of the sensor
lens. You should easily hear the ScareCrow’s
internal water valve click open, then click
closed 3 seconds later. There is an 8 second
reset interval after the valve closes when the
sensor does not detect motion.
If you hear no clicking, try a new battery and try hooking your ScareCrow
up to water. If the problem persists, call the factory toll-free at 1.800.767.8658
/ 1.250.413.3250 for assistance or email: support@contech-inc.com
4. Assemble stake and attach sprinkler head and stake to housing.
5. Connect hose and position the ScareCrow.
Aim the ScareCrow towards the area you
want to protect. Push the spike into the
ground by stepping on the footrest.
Do not push on the sensor housing or
sprinkler head. If the ground is too
hard or otherwise unsuitable for the
plastic stake, try placing the ScareCrow in a flower pot filled with a
weighted material like sand or gravel
Multiple Connections
If you have more than one ScareCrow you can hook them up in series by
removing the flow through cap and connecting them as shown below.
5 5
CRO-200
RESET/OFF
5
These fittings should only be hand tightened.
Sensitivity knob

Contech ScareCrow Specifications

General

Brand	Contech
Model	ScareCrow
Category	Lawn and Garden Equipment
Language	English