Continental Fireplaces CDVS600-N User Manual

1
W415-0162 / E / 03.05.04
INSTALLATION AND OPERATION INSTRUCTIONS FOR:
VENTED GAS FIREPLACE HEATER
NATURAL GAS MODELS CDVS600-N and CS600-N
PROPANE GAS MODELS CDVS600-P and CS600-P
Model CS600 is made up of Model CDVS600 and the Adapter Kit GS-150KT
CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS, CSA 2.33, ANSI Z21.88 FOR VENTED GAS FIREPLACE HEATERS
Installation and service must be performed by a qualified installer, service
agency or the gas supplier.
WARNING:
If the information in these instructions is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapours and liquids in the vicin-
ity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your build
ing.
• Immediately call your gas supplier
from a neighbour's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.

Continental Fireplaces CDVS600-N Specifications

General

Model	CDVS600-N
Category	Gas Heater
Fuel Type	Natural Gas
Ignition Type	Electronic Ignition
Vent Type	Direct Vent
Warranty	Limited Lifetime

Summary

FOR YOUR SAFETY

WHAT TO DO IF YOU SMELL GAS

Provides essential steps to take if gas is detected.

CONTINENTAL GAS FIREPLACE PRESIDENT'S LIFETIME LIMITED WARRANTY

CONDITIONS AND LIMITATIONS

Crucial details of the warranty coverage and restrictions.

GENERAL INSTRUCTIONS

LOCATION & CLEARANCES

CDVS600 AND CS600 CLEARANCES

Specifies minimum clearances for CDVS600 and CS600 models to combustibles.

DIRECT VENT SPECIFICS - MODEL CDVS600

VENTING LENGTHS & AIR TERMINAL LOCATIONS

Details minimum and maximum vent lengths and air terminal placement for CDVS600.

AIR TERMINAL INSTALLATIONS

INSTALLATION CLEARANCES

REAR VENT HORIZONTAL TERMINATION

WALL & CEILING PROTECTION

VERTICAL INSTALLATION

HORIZONTAL VENTING INSTALLATION

VERTICAL VENTING INSTALLATION

B-VENT SPECIFICS - MODEL CS600

GAS INSTALLATION

LOG PLACEMENT

POSITIONING THE LOGS

OPERATION / MAINTENANCE

MODEL CS600 SPILL SWITCH

Explanation and function of the spill switch on CS600 models.

VENTING ACTION CHECK

Procedure to verify correct venting action before leaving the unit with the customer.

OPERATING INSTRUCTIONS AND GAS SMELL PROCEDURE

General operating guidelines and essential steps to follow if gas is detected.

LIGHTING INSTRUCTIONS

PILOT BURNER IGNITION

Detailed steps for lighting the pilot burner and main burner.

TO TURN OFF GAS

MAINTENANCE

PRE-SERVICE SAFETY AND CLEANING

ADJUSTMENTS

PILOT BURNER ADJUSTMENT

VENTURI ADJUSTMENT

TROUBLE SHOOTING GUIDE

PILOT AND BURNER ISSUES

Addresses problems like pilot not lighting, going out, or main burner issues.

THERMOCOUPLE AND VALVE PROBLEMS

Troubleshooting for thermocouple faults, valve issues, and gas supply problems.

TROUBLESHOOTING CONTINUED

MAIN BURNER AND VENTING ISSUES

Covers main burner failure, venting problems, and exhaust fume issues.

FLAME AND DEPOSIT ISSUES

Addresses flame appearance problems and white/grey film deposits on surfaces.