5. Only use fresh batteries as specified. Do not mix new and old batteries.
6. Read the user’s manual thoroughly before operating the unit.
OPERATIONAL DIFFICULTIES
If this temperature meter does not function properly for any reason, please
replace the batteries with new, high-quality batteries (see “Battery Installa-
tion” sections). Low battery power can occasionally cause any number of
“apparent” operational difficulties. Replacing the batteries with new fresh
batteries will solve most difficulties.
What to do if the unit appears to not be receiving a
signal.—Suggestions
Keep in mind that the remote transmitter sends a signal to the main re-
ceiver every thirty seconds. Be patient, wait 2 minutes to see if a signal has
been received.
Make certain that the channel number on the remote transmitter (displayed
on the remote transmitter LCD) and the channel number on the main
receiver (displayed on the receiver LCD) are identical.
If there are two or more remote transmitters, make certain that none is set
to the same channel number.
Remove the battery cover on the main receiver (unit with large LCD
display). Remove the batteries. Do not put the batteries in until the remote
transmitter is activated. The goal is to activate the remote transmitter before
the main receiver.
Remove the back panel of the remote transmitter. Remove the batteries,
wait 20 seconds, and put them back in the unit. Then, using a stylus or
straightened paper clip, press the RESET button. Observe on the remote
transmitter LCD a momentary reset to “888” on the display, release the
RESET button.
Place the batteries in the main receiver unit. Replace the battery cover.
Using a stylus or straightened paper clip, press the RESET button on the
To Next Page
Loading...