2. Place the remote transmitter in a vertical or stand-up position.
3. Place the main receiver in a vertical or stand-up position.
4. Place the remote transmitter and the main receiver in locations where
the radio signal does not need to be sent through metal panels, thick
walls, multilevels, etc.
5. Try several locations. Sometimes moving either unit several feet or as
little as 6 inches will make a significant difference.
6. Try several different orientations. That is, turn the remote transmitter
and/or the main receiver unit to the left, then to the right.
7. Try setting both the remote transmitter and the main receiver to channel
2.
8. Replace the batteries in both units with new alkaline batteries and
repeat the above procedures.
On occasion radio-transmitted signals may not work in some environ-
ments. If this unit does not work in your environment, call 281 482-1714 for
help in answering questions.
To Next Page
Loading...