Why is my CONVEY-ALL Farm Equipment engine labouring?
The engine might be labouring because the belt is sticky due to oily product or wet/snowy conditions. Clean the belt to resolve this. Another possible cause is a dirty air cleaner. Clean the air cleaner or replace the air filter.
What to do if the CONVEY-ALL Farm Equipment wireless handset is not functioning?
If the wireless handset isn't functioning, first ensure the batteries are good as they may have died during storage. If you've replaced the batteries and it still doesn't work, you may need to synchronize the wireless handset to the receiver.
What to do if charging the battery will short the wireless electrical system in CONVEY-ALL Farm Equipment?
Boosting the current can short the electrical system. If boosting to start the engine, remove the fuse from the receiver box. If recharging the battery, disconnect it from the CST.
What to do if there is no hydraulic flow in my CONVEY-ALL Farm Equipment?
If there's no hydraulic flow, the flow valve may be closed. Open the flow circuit valve. Alternatively, the hydraulic filter might be plugged, in which case you should replace it.
What to do if the CONVEY-ALL Farm Equipment rear conveyor does not shuttle sideways?
The rear conveyor may not shuttle sideways if it's not in the “rotation centre”. Swing the conveyor 180° from the stow position until the green LED lights up. Also, ensure the rear conveyor hopper is fully dropped and the rear conveyor discharge is fully raised, as limit switches must activate in both cases.
How to fix CONVEY-ALL Farm Equipment rear conveyor belt that does not run?
The rear conveyor belt will only operate when its hopper is directly below the slave discharge. Swing the conveyor 180° from the stow position until the green LED lights up, drop the hopper completely, and shuttle the conveyor frame to the center, ensuring all limit switches are activated.
What to do if CONVEY-ALL Farm Equipment rear conveyor does not swing and discharge does not raise or lower?
The conveyor hopper may not be positioned directly below the slave discharge, which means the limit switch isn't activated. To resolve this, swing the conveyor 180° from the stow position until the green LED lights up when centered, drop the hopper, raise the discharge completely, and shuttle the conveyor frame to the center, ensuring all limit switches are activated.
General| Model | CST-1550 |
|---|---|
| Category | Industrial Equipment |
| Type | Conveyor |
| Capacity | 500 bushels |
| Tire Size | 11L-15 |
| Hydraulic Drive | Yes |
| Material | Steel |
| Unload Rate | 9, 000 bushels per hour |
| Auger Diameter | 15 inches |
| Application | Grain handling |
To Next Page