User Manual
Model: HX106 (Updated Version)
1. Clock Setting :
1. After installing the battery, it shows "CLOCK" on the screen, long press "START/STOP " key for 3 seconds
to stop flashing on the screen.
2. then short press "HOUR/MIN/SEC" key to set the clock time, long press "HOUR/MIN/SEC" key to fast
forward.
3. After setting, press "START/STOP " key to start working and you will see the flashing on the screen again.
4. 15 seconds later, the "HOUR/MIN/SEC" key will be locked, if you want to reset the time, long press
"START/STOP " key for 3 seconds until no flashing on the screen, then reset the time again.
2. Count Up Setting
1. Press the MODE key until you see TIMER mark on the screen, and it shows 0:00 00 at this time.
2. Press the "START/STOP " key to start counting up and you will see COUNT-UP mark on the screen.
3. Press "START/STOP " key to pause timing and press the same key again to continue.
4. While you pause the timing, press CLEAR key to reset the timing.
NOTE: 24-hours Count-up timing system displayed.
3. Count Down Setting
1. Press the MODE key until you see TIMER mark on the screen, and it shows 0:00 00 at this time.
2. Short press "HOUR/MIN/SEC" key to set the time, long press "HOUR/MIN/SEC" key to fast forward.
3. After setting, press "START/STOP " key to start countdown and the countdown timing can be set up to 24
hours.
4. You may press "START/STOP " key to pause or continue during this process. When the countdown finished,
the alarm ring (or flash) for 60 seconds, you may press any key to stop the alarm (or flash).
5. If you need to reset the timing, press "START/STOP " key to pause the timing first and press CLEAR key to
reset.
NOTE: This upgraded timer comes with MEMORY FUNCTION, after you reset the timing, press the CLEAR key
again and it shows the same timing you set previously, no need to set it again and again.
4. Alarm Setting :
1. Press the MODE key until you see ALARM mark on the screen, and it shows 12:00 00 AM at this time.
2. Short press "HOUR/MIN/SEC" key to set the time, long press "HOUR/MIN/SEC" key to fast forward.
3. After setting, press "START/STOP " key, you will see flash on the screen but the timing is not changed,
which means alarm function starts. The alarm will ring(or flash) for 60 seconds when time is up, you may press
To Next Page
General