Issue 2 26/11/2019 5
TO USE (BASIC OPERATION)
1. Place the coffee maker on a stable, flat, heat resistant
surface and away from surfaces that may be damaged by
steam.
2. Lift the lid of the coffee maker and fit the filter holder as
shown in parts diagram. Insert the mesh filter into the filter
holder and add the fresh ground coffee for the required
number of cups into the mesh filter according to personal
taste.
3. Fill the water reservoir to the required level using the
graduated markings on the clear panel as a guide. Do not fill
past the maximum 12 cups (otherwise water will flow out of
the overflow onto the work surface) or fill below the minimum
2 cups levels.
4. Close the lid and place the glass jug onto the hotplate.
5. Fully unwind the cable and plug in, the display will initially
illuminate and the time digits ‘00 00’ will flash. Press the
SET or ON/OFF button to stop the digits flashing.
6. For safety do not allow the cable to dangle over the edge of
units.
7. Press the ON/OFF button, the power indicator ( ) will
illuminate in the display and the coffee maker will start to
operate.
8. The coffee maker element will switch off automatically when
all the coffee has been brewed but the power indicator will
remain lit for 40 minutes to indicate that the hotplate is still
keeping the coffee warm.
9. Switch the coffee maker off using the ON/OFF button when
the jug is empty and to avoid damaging the glass jug never
replace the empty glass jug onto the warm hotplate.
10. To stop or interrupt the coffee making process, switch the
appliance off using the ON/OFF button or unplug from the
mains.
To Next Page
Loading...
Need help?
General
