EasyManua.ls Logo

Cookworks SEB177S1B-P - Page 11

Cookworks SEB177S1B-P
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12inch(30cm)
8.0inch(20cm)
8.0inch(20cm)
3.0inch(7.5cm)
min85cm
Installation
Please note
Electrical connection
10
This oven is fitted with a plug and must be
only connected to a properly installed earthed
socket. In accordance with the appropriate
regulation, the socket must only be installed
and the connecting cable must only be
replaced by a qualified electrician. If the plug
is no longer accessible following installation
and all-pole isolating switch must be present
on the installation side with a contact gap of at
least 3mm.
1. Select a level surface that provide enough
open space for the intake and / oroutlet vents.
A minimum clearance of 3.0 inches (7.5cm) is
required between the oven and any adjacent
walls. One side must be open.
(1) Leave a minimum clearance of 12 inches
(30cm) above the oven.
(2) Do not remove the legs from the bottom of
the oven.
(3) Blocking the intake and/or outlet openings
can damage the oven.
(4) Place the oven as far away from radios
and TV as possible. Operation of microwave
oven may cause interference to your radio or
TV reception.
2. Plug your oven into a standard household
outlet. Besure the voltage and the frequency
is the same as the voltage and the frequency
on the rating label.
WARNING: Do not install oven over a range
cooktop or other heat-producing appliance. If
installed near or over a heat source, the oven
could be damaged and the warranty would be
void.

Related product manuals