Cool-Living CL-D025BA-35PT

Questions and Answers

J
jessicamacdonaldAug 5, 2025
Why Cool-Living CL-D025BA-35PT Dehumidifier does not start?
- R
  Roger MartinAug 5, 2025
  Your Cool-Living dehumidifier might not be starting due to several reasons. First, ensure the dehumidifier's plug is fully inserted into the outlet. Then, check your house's fuse or circuit breaker and replace the fuse or reset the breaker if necessary. Also, the dehumidifier might have reached its preset level, or the bucket could be full. Another potential issue is that the water bucket isn't correctly positioned. Finally, be aware that there's a protective time delay of up to 3 minutes to prevent compressor overload, so the unit might not begin normal dehumidification immediately after being powered on.
A
Adam JarvisAug 10, 2025
Why is my Cool-Living Dehumidifier not drying the air properly?
- J
  jenniferadkinsAug 10, 2025
  Several factors can affect your Cool-Living dehumidifier's ability to dry the air effectively. Ensure enough time has passed for it to remove the moisture. Check that curtains, blinds, or furniture aren't blocking the front or back of the unit. The humidity control setting might be too high. Verify that all doors, windows, and other openings are securely closed. Also, the room temperature might be too low, specifically below 5°C (41°F). Finally, check for any sources of water vapor in the room.
M
marymcculloughAug 15, 2025
What to do if my Cool-Living Dehumidifier is making a loud noise?
- J
  Joe RodgersAug 15, 2025
  If your Cool-Living dehumidifier is operating loudly, there are a few things you can check. First, the air filter may be dirty, so clean it. Another reason may be that the unit is tilted instead of upright. Lastly, the floor surface might not be level.
R
Richard NorrisAug 20, 2025
What to do if I see water on the floor near my Cool-Living CL-D025BA-35PT Dehumidifier?
- A
  Angela HardyAug 20, 2025
  If you find water on the floor near your Cool-Living dehumidifier, the hose connection may be loose. Alternatively, if you're using the bucket to collect water, check that the back drain plug is properly inserted.
H
hknightAug 25, 2025
Why is water draining in the bucket when Continuous Mode is on in my Cool-Living Dehumidifier?
- S
  Shirley WolfAug 26, 2025
  When operating your Cool-Living Dehumidifier in Continuous Mode, a garden hose must be used for proper drainage.
B
Betty MeadowsAug 30, 2025
Why is there frost on the coils of my Cool-Living Dehumidifier?
- M
  Michael LandryAug 30, 2025
  The appearance of frost on the coils of your Cool-Living dehumidifier is normal, as the unit has an auto-defrost feature.

Summary

Safety Warnings

General Safety Instructions

Important safety precautions for operating the dehumidifier, covering general use and electrical safety.

Features

Dehumidifier Features

Highlights dehumidifying capability, portability, adjustable humidistat, energy savings, and auto defrost.

Product Overview

Lists and identifies all parts of the dehumidifier with a diagram for user reference.

Operating Instructions

Control Panel Operation

Explains the function and operation of the Power, Filter, Fan Speed, Humidity, and Mode buttons.

Timer and Child Lock Functions

Details how to set auto timers for on/off and activate the child lock feature.

Water Removal Methods

Drain Bucket Method

Instructions for emptying the water bucket when full, including notes on its care.

Continuous Drainage Method

Guide for connecting a garden hose for continuous water removal and setup instructions.

Cleaning and Maintenance

Cleaning and Storage

Covers cleaning procedures for the grill, case, bucket, air filter, and guidelines for storage.

Troubleshooting

Common Issues and Solutions

Addresses common problems like unit not starting, poor drying, noise, frost, and leaks with solutions.

Diagnostic Error Codes

Lists self-diagnosing error codes (E1, E2, EH) and their potential causes.

Warranty and Product Registration

Limited Warranty Details

Details the terms and conditions of the 6-month limited warranty, coverage, and exclusions.

Registration and Support

Instructions for product registration, customer support contact information, and warranty card.

Overview

Function Description
Important Technical Specifications
Usage Features
Maintenance Features
Troubleshooting and Self-Diagnosing Codes

This document is an owner's manual for COOL-LIVING dehumidifiers, specifically models CL-D025BA-35PT and CL-D026BA-50PT. It provides essential information for setting up, operating, maintaining, and troubleshooting these devices.

Function Description:

The COOL-LIVING dehumidifier is designed to powerfully remove moisture from the air using refrigeration technology. Its primary function is to decrease the humidity level in a room, thereby keeping the indoor air dry and comfortable. This helps prevent the growth of mold, mildew, and bacteria, and improves overall air quality. The unit is suitable for use in domestic environments.

Important Technical Specifications:

While specific numerical technical specifications like power consumption or dehumidification capacity in pints per day are not explicitly listed in the provided pages, the manual highlights several key features:

Energy Star Rated: The dehumidifier is Energy Star certified, indicating it is energy-efficient and can help save on utility bills. Energy Star units are noted to cost 30% less to operate compared to non-Energy Star units.
Refrigerant: The unit uses a flammable refrigerant. This is an important safety note, indicating that repairs should only be performed by trained service personnel and the refrigerant tubing should not be punctured. Disposal must be done in accordance with federal or local regulations for flammable refrigerants.
Adjustable Relative Humidity (RH) Range: The adjustable RH range is between 35% RH to 80% RH, allowing users to select their preferred humidity level in 5% increments.
Timer: The timer can be set for auto-on or auto-shut-off. For settings up to 10 hours, adjustments are in 30-minute increments. Beyond 10 hours (up to 24 hours), adjustments are in 1-hour increments.
Clearance Space: A 12-18 inch clearance space around the unit is required for proper operation.

Usage Features:

The dehumidifier offers a range of user-friendly features:

Powerful Dehumidifying Capability: Effectively removes moisture to maintain a dry and comfortable indoor environment.
Unique Portable Design: Compact and lightweight, equipped with casters on the bottom for easy movement from room to room.
Adjustable Humidistat: Allows users to select different dehumidification levels to suit various room requirements.
Automatic Defrost: When frost accumulates on the evaporator coils, the compressor automatically cycles off, and the fan continues to run until the frost disappears. Once defrosted, the compressor or fan restarts, and dehumidification resumes.
Control Panel: Features a user-friendly control panel with buttons for Power, Filter, Fan Speed, Humidity, Mode, and Timer.
Power Button: Turns the dehumidifier on and off.
Filter Button/Alert: An alert light indicates when it's time to clean the air filter.
Fan Speed Button: Cycles through High, Medium, and Low fan modes, allowing users to adjust for increased moisture removal or quieter operation.
Humidity Button: Used to set the desired humidity level (35% RH to 80% RH) in 5% increments.
Continuous Operation (CO): By pressing the MODE button until "CO" appears on the digital display, the unit will operate continuously regardless of the room humidity.
Mode Button: Offers preset humidity level settings for different locations, such as "Comfort" and "Basement," optimizing performance for the specific environment.
Timer Auto On/Shut-Off: Allows programming the unit to automatically turn on or off after a set period (from 30 minutes up to 24 hours).
Child-Lock Mode: A safety feature that locks the control panel to prevent accidental changes to settings. It is activated by pressing and holding the TIMER button for 3 seconds, and a LOCK indicator lights up.
Water Collection Options:
- Drain Bucket: When the bucket is full, an indicator light turns on, the unit stops, and a buzzer sounds three times. The bucket is easily removed by pressing its sides and pulling it out.
- Continuous Drainage: For uninterrupted operation, a standard garden hose (not included) can be attached to the continuous drainage port on the back of the unit, leading to a floor drain. The unit must be on a level surface, and the hose should be free of kinks or knots. This mode requires setting the unit to "CONTINUOUS" via the MODE button. The water bucket must remain in place and securely seated even when using continuous drainage.

Maintenance Features:

The manual provides clear instructions for maintaining the dehumidifier to ensure its longevity and efficient operation:

Safety Precaution: Always switch off and unplug the dehumidifier before any cleaning or maintenance.
Cleaning the Grill and Case: Use water and a mild detergent; avoid bleach or abrasives.
Cleaning the Bucket: Clean the water bucket every few weeks with cold or lukewarm water and mild detergent to prevent mold, mildew, and bacteria growth. Do not remove the float from the bucket. Avoid harsh cleaning agents like gasoline, benzene, or thinners, as they can damage the bucket.
Cleaning the Air Filter: The filter can be easily removed, washed with clean water, dried, and re-installed.
Storing the Dehumidifier:
1. Allow the system to dry out naturally for one full day before storage.
2. Clean the unit, water bucket, and air filter.
3. Wrap the power cord using the power cord buckle.
4. Cover the unit with a plastic bag.
5. Store the unit upright in a dry, well-ventilated area.

Troubleshooting and Self-Diagnosing Codes:

The manual includes a troubleshooting section to address common issues and a list of self-diagnosing error codes:

Common Problems & Solutions: Covers issues like the unit not starting (plug, fuse, bucket full, protective time delay), not drying air effectively (blocked grilles, humidity setting, open doors/windows, low room temperature, water vapor source), loud noise (dirty air filter, tilted unit, uneven floor), frost on coils (normal, auto defrost), and water on the floor (loose hose connection, drain plug removed).
Self-Diagnosing Codes:
- E1: Compressor Overheat Protection
- E2: Condenser Overheat Protection
- EH: Humidity Sensor Malfunction