4
5
32” Tower Fan with Oscillation
SAVE THESE INSTRUCTIONS
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use
with adequate electrical system that is up
to code.
CAUTION: TO PREVENT ELECTRIC SHOCK,
this product has a polarized two prong plug
(one blade is wider than the other) that
must be fully inserted in to a matching
properly grounded outlet. This plug is
designed to fit a polarized outlet only one
way. If the plug does not fit fully into the
outlet, reverse the plug. If the plug still does
not fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, do not use this
product wit
h any solid-state speed control
device.
DO NOT operate any fan with a damaged cord
or plug or after fan malfunctions, has been
dropped or damaged in any manner.
Do not operate fan with a broken blade, safety
cage or any visual imperfections. Disconnect
power before servicing.
DO NOT run power cord under carpeting. DO
NOT cover cord with throw rugs, runners or the
will not be tripped over. Avoid the use of
extension cords due to risk of fire. If an extension
cord must be used, the cord must be minimum
14 AWG and rated not less then 1875 watts. Do
not use an extension cord unless the plug can be
completely inserted into its receptacle. Unplug
the fan when not in use. Do not operate fan with
its ventilation obstructed.
Operating Instructions
Fan Operation
Always operate the fan in the upright position following all instructions and recommendations listed
in this manual.
Fan Location
Place the fan in the area of the room that will provide proper fan cooling.
Fan Connection
Plug fan directly into 120 Volt A.C., 60 Hz wall outlet. Be sure plug fits tightly in outlet. A loose
connection may cause overheating and damage to the plug or fan.
Note: To prevent overloading a circuit, do not plug the fan into a circuit that is servicing other
electrical needs.
Turning Fan On/
Place fan on stable level surface. Plug fan into proper polarized outlet. To start the fan, rotate top
control dial to desired fan speed (1, 2 or 3). Rotate the dial clockwise for standard use and
counter-clockwise for oscillation use. See Control Panel below. Rotate top control dial again to OFF
position to discontinue use. Unplug fan when not in use.
Fan Speed And Oscillation
Rotate top control dial to desired fan speed (1, 2 or 3). Rotate the dial clockwise for standard use and
counter-clockwise for oscillation use. See Control Panel below.
Fan Base Assembly
Simple assembly is required to use this fan.
1. Rotate the base holder (F) o , which is at
the bottom of the fan housing.
2. Place the Rear base panel (B) between the
fan housing (D) and base holder( F), in the
right direction.
3. Align the Rear base panel (B) and Front
base panel (A) together
4. Put the base holder (F) back and tighten it
to hold the base panels on the fan housing
(D).
Fan speed
with oscillation
Fan speed
without oscillation
Control Panel
1
2
3
4
To Next Page
Loading...
