TROUBLE SHOOTING
Jet system does not operate
Problems
Heating system does not operate
Filtering system does not operate
Spa leakage
Water not clean
Display temperature is higher than 42
degrees, after stopping heating function
• Air pump is too hot
• Something is wrong with the power box
Probable causes
• Temperature set too low
• Dirty lter cartridge
• Improper water levels
• Heating element failed
• Dirty lter cartridge
• Something is wrong with the power box
• Too low voltage or incorrect frequency
• Spa is torn or punctured
• Insufcient ltering time
• Dirty lter cartridge
• Improper water maintenance
• The display temperature may suddenly rise
because the residual water in heating tank
will be continue heated by residual tem-
perature.
• Inlet blocked
• Unplug the air pump. After the air pump has cooled, insert the plug and press the Jet
button to activate.
• Call for service if it does not reset.
Solutions
• Set to a higher temperature (20-42°C).
• Clean/replace the lter cartridge in time.
• Add water to specied levels.
• Clean/replace the lter cartridge in time.
• Call for service if it does not reset.
• Ask professional electrician to check whether the household input voltage or frequen-
cy is normal
• Use provided repair patch
• Increase ltration time.
• Clean/replace the lter cartridge.
• Refer to the chemical manufacturer’s instructions.
• The temperature will return to normal few minutes later.
• Clean the inlet
EN
To Next Page
Loading...