Cooper LCR 6200 User Manual

Instructional Leaflet
Customer Service: 1-800-815-2258
This instructional leaflet contains general installation
information for the LCR 6200 Load Control Receiver.
The LCR 6200 is used to control remote electric
loads and is activated by commands sent through
the SelectComm™ and ZigBee communication
modules.
No special test equipment or programming is
required to install the LCR 6200 in the field.
The LCR 6200 addressing must be configured for
your demand response system prior to operation.
CAUTION: Observe precautions for handling
electrostatic sensitive devices.
MISE EN GARDE: Respectez les précautions de
manipulation des dispositifs à décharge
électrostatique.
LCR 6200
Load Control Receiver

Cooper LCR 6200 Specifications

General

Tuning range	FM 87.5 - 108 MHz, AM 530 - 1710 kHz
Power output	40 watts per channel into 8Ω (stereo)
Frequency response	20Hz to 20kHz
Total harmonic distortion	0.5%
Input sensitivity	2.5mV (MM), 150mV (line)
Signal to noise ratio	75dB (line)
Output	150mV (line)
Speaker load impedance	8Ω to 16Ω
Dimensions	420 x 135 x 330mm
Weight	7.9kg

Summary

Safety Information

Safety Instructions

General danger and warning statements for PLC equipment operation and maintenance.

Hazard Statement Definitions

Explains hazard symbols (DANGER, WARNING, CAUTION) and their meanings for user safety.

Installing the LCR 6200

Commissioning the ZigBee Module

LCR 6200 LEDs

Explains the meaning of Load Status (Red) and LCR Status (Green) LEDs on the device.

Test Button

Cancel Control and Power Detection at Power-On

Use the Test button to bypass power stability detection and cancel controls.

Test Relay Control

Use the Test button to control the relay for a configurable time.

Commissioning via Test Button

Use the Test button to initiate ZigBee module network joining.

LCR 6200 Specifications

FCC Compliance Statement

Disclaimer of Warranties and Limitation of Liability