Please read carefully before use and retain for future reference.
GETTING STARTED PARTS & ASSEMBLY
Remove the soup maker and
accessories from the box.
Remove any packaging from
the product.
Place the packaging inside
the box and either store or
dispose of safely.
Before using the soup maker
for the first time wipe down
the jug and lid with a damp
cloth using a mild detergent.
Dry thoroughly before use.
Do not immerse the unit or
the jug in water or any other
liquids.
Caution: the jug contains very
sharp blades and should be
handled with care at all
times.
The soup maker has two
programmed soup settings to create a chunky or smooth soup and also has a reheat function
enabling precooked soup to be reheated before serving.
The built-in blender blades can be used to allow the soup maker to be used solely as a
blender to make purees, dips and dressings.
The soup maker is fitted with several safety features including an interlocking lid cut-out, a
minimum liquid sensor, a hot liquid overflow sensor for safe use at all times and safety
micro-switch cut-off on the motor base.
BEFORE STARTING COOKING
Place the base unit of soup maker on a flat, heat-resistant, stable surface. Carefully position
the jug on the base unit aligning the connections in the base of the jug handle with those in
the base unit, ensuring the jug is secure.
Plug the soup maker to the mains power supply, fill with liquid to desired level (must be
above “WATER MIN.” marking on jug) and fit the lid to the soup maker by aligning the
“Close/Power on” symbol on the lid with the line on the top of the handle.
Once aligned, turn the lid in the direction of the arrows on the lid until the lid lock symbol
aligns with the line on the handle. Ensure the measuring cup stopper is fitted to the top of
the lid.
Press the START/STOP button to turn the soup maker on. The button will illuminate indicating
the soup maker is on. If at this point the alarm sounds, disconnect the soup maker from the
mains power supply and check that the lid is properly fitted and the fluid level is correct as
described on trouble shooting, then re-connect to the mains and power up.
To Next Page
Need help?
General