What to do if CooperSurgical K-Systems L100 IVF has no light?
If the CooperSurgical Desktop light is not working, first, ensure that the device is properly connected to the power supply. If the connection is correct, check if the light is simply turned off; press and hold the UP key for 5 seconds to turn it on. If the LED is broken or the bulb needs replacement, contact your authorized service provider.
General| Brand | CooperSurgical |
|---|---|
| Model | K-Systems L100 IVF Series |
| Category | Desktop |
| Language | English |
Lists contact details for European and U.S. service representatives for support.
Essential steps and checks required before operating the workstation.
Emphasizes the necessity of trained and authorized personnel for operation and repair.
Outlines the terms and conditions of the workstation's warranty.
Explains the meaning of various safety symbols found on the workstation.
Lists critical precautions and warnings to ensure safe use of the equipment.
Provides vital safety instructions for operating and maintaining the workstation.
Guidelines for setting up the workstation, including placement and ventilation.
Describes the Normal and Standby modes of the laminar airflow system.
Guides on activating and managing the laminar airflow system modes.
Introduction to the workstation's integrated heating system.
Details how to set and adjust the desired temperature via the control panel.
Procedure for viewing and setting temperature for the right side of dual workstations.
Procedure for viewing and setting temperature for the left side of dual workstations.
Explains the alarm system for temperature alerts and error modes.
How to turn on, adjust intensity, and turn off the microscope light.
Explains the procedure for entering and navigating the workstation's menu interface.
Presents a visual overview of the main menu structure and options.
Introduces the User Menu for accessing timers and settings.
Guides on setting a timer for the fan to activate at a specific time.
Details setting a timer for the heater to turn on automatically.
Guides on setting the internal clock time of the workstation.
Details setting the timer for automatic start of heater and fan.
Detailed steps for calibrating the temperature on Zone-1.
Detailed steps for calibrating the temperature on Zone-2.
Detailed steps for calibrating the temperature on Zone-3.
Guides on calibrating Zone-4/Zone-L temperature for dual workstations.
Details calibrating Zone-5 temperature for dual workstations.
Explains calibrating Zone-6 temperature for dual workstations.
Guides on calibrating the temperature within the workstation's tunnel.
Instructions for calibrating the heated glass on the right side of dual units.
Instructions for calibrating the heated glass on the left side of dual units.
Explains how to restore the workstation to its original factory default settings.
Step-by-step guide for validating and calibrating the tabletop temperature.
Explains the procedure for calibrating the heated glass surface.
Solutions for common problems related to the heating system.
Action to take when an alarm occurs during laminar flow operation.
To Next Page
