What to do if CooperSurgical K-Systems L126 DUAL IVF Desktop has no light?
If the CooperSurgical Desktop light is not working, first, ensure that the device is properly connected to the power supply. If the connection is correct, check if the light is simply turned off; press and hold the UP key for 5 seconds to turn it on. If the LED is broken or the bulb needs replacement, contact your authorized service provider.
General| Brand | CooperSurgical |
|---|---|
| Model | K-Systems L126 DUAL IVF |
| Category | Desktop |
| Language | English |
Provides contact details for European and US service representatives and new purchases.
Instructions and warnings for safely moving the heavy workstation unit.
Explains various hazard, warning, and informational symbols found on the equipment.
Lists precautions for safe use, including package inspection and filter usage.
Crucial safety guidelines covering usage, servicing, and environmental hazards.
Describes the Normal Mode and Standby Mode for laminar airflow.
Explains the gassing station for pH control and gas mixture handling.
Instructions for activating and managing the laminar airflow fan speeds.
Procedure for setting separate temperature points for the L126 Dual workstation.
Explains workstation alarms, visual/audible alerts, and display messages.
Setting unique temperature set-points for the left and right sides of the L126 Dual.
Detailed steps for setting the workstation's internal clock.
Setting timers for automatic activation of HEAT and FAN functions.
Allows modification of the fan speed to different levels (90, 95, 100, 120).
Procedure for calibrating the temperature of Zone-1 on heated surfaces.
Procedure for calibrating the temperature of Zone-2 on heated surfaces.
Procedure for calibrating the temperature of Zone-3 on heated surfaces.
Procedure for calibrating temperature on Zone-4/Zone-L for L126 Dual.
Procedure for calibrating the temperature of Zone-5 on heated surfaces.
Procedure for calibrating the temperature of Zone-6 on heated surfaces.
Procedure for calibrating the temperature within the workstation's tunnel.
Calibrating temperature for the heated glass on the right side.
Calibrating temperature for the heated glass on the left side.
Procedure to reset the workstation to factory defaults, with data loss warning.
Instructions for connecting gas bottles or plumbed circuits with pressure details.
Detailed instructions for validating and calibrating tabletop temperature zones.
Step-by-step guide for temperature measurement, averaging, and comparison.
Procedure for calibrating the heated glass, with single measurement location.
Details fuse types, ratings for different voltages, and replacement instructions.
Common problems and solutions for the LED light source.
Identifies symptoms, causes, and actions for heating system issues.
Addresses issues related to the laminar flow system, like fan alarms.
Troubleshooting for keyboard errors, missing display segments, or erratic functions.
Addresses issues such as no microscope light, bad bulbs, or faulty connections.
General guidelines for cleaning internal surfaces and handling spills.
Steps for daily cleaning using distilled water and disinfection solution.
Instructions for changing the pre-filters every three months.
Steps for disconnecting power and replacing the interior light tubes.
To Next Page
