Astrid Bed - assembly instructions
Step 7 - optional
• Your Astrid headboard may be positioned in two heights depending on the thickness of the mattress used. The bed comes
packaged with the headboard in the lower position.
• To Adjust the height, use the Allen wrench to unscrew all the bolts at the back of each headboard panel.
• By rotating the panels 180 degrees you will add an extra 4” of height to the headboard.
• To reattach, begin but do not fully tighten all bolts in each of the two panels.
• After all bolts have been started, use the Allen wrench to fully tighten all locations.
www.copelandfurniture.com
Note on Split Headboard Version - In order to preserve the continuity of the
wood grain across the two panels, be sure to rotate them as if they were a single
panel as in the diagram.
To Next Page
Loading...