Water flow
outlet connection
HOSE BARB INLET
HOSE BARB
INLET
Warning:
Never install a
valve directly
on the tubing
between the
main body and
the aquarium.
Note: Make sure that the tubing is not carrying the weight of the Turbo-Twist UV Sterilizer.
Use the Turbo-Twist brackets to support the unit.
Note: When the Turbo-Twist is turned on, you may
see patterns on the body of the unit. This does not
affect the quality ot the unit.
Connect the tubing
between the
water flow outlet and the hose
barb inlet.
It is recommended that
a
prefilter be used with the
Turbo-Twist to limit the amount
of debris entering the sterilizer.
Cleaning the quartz sleeve
Be sure to disconnect power outlet and
turn off the pump and let the water drain
out of the Turbo-Twist UV sterilizer
before cleaning.
Turn on water supply to the Turbo-Twist. Once proper water flow has been established,
tilt the unit and let the air bubbles inside the tubing and the main body escape. Examine
the unit and check for any leaks.
Connect the Turbo-Twist to the power supply. Verify that the
UV lamp is working properly indicated by the light blue glow
emitted through the lamp on indicator. The light from the lamp
on indicator will not affect the skin or the eye.
WAT
ER FLOW
WATER FLOW
MAINTENANCE
To ensure superior kill-rates of the sterilizer, the
quartz sleeve should be cleaned periodically.
(PICTURE 1)
SAFELOCK
Once clean, reinstall the quartz sleeve
into the main body and push the red
safelock into the lock position.
QUARTZ HOUSING
MAIN BODY
(PICTURE 2)
(PICTURE 3)
QUARTZ SLEEVE
Lift the red safelock and unlock the
quartz housing. (Picture 1)
Carefully twist the quartz housing and
the main body opposite of each other.
(Picture 2)
Slide the quartz sleeve out of the main
body. (Picture 3)
Wipe the quartz sleeve using a soft,
damp cloth. Do not use household
cleaners or abrasive scrubbers to
clean the quartz housing.
Never look directly at the unshielded lamp as the ultraviolet
radiation is harmful.
Disconnect the unit from the power supply when installing or
repairing the UV sterilizer.
Never submerse the unit in water.
CAUTION
Never look directly at the unshielded lamp as the ultraviolet
radiation is harmful.
Disconnect the unit from the power supply when installing or
repairing the UV sterilizer.
Never submerse the unit in water.
CAUTION
CANISTER
FILTER
WAT
ER FLOW OUTLET
LAMP ON
INDICATOR
To Next Page
Loading...
Need help?
General
