A
B
7
1. Gently pull the trigger to move your model forward.
The speed is proportional, the more you pull the trigger, the faster the model moves forward.
2. Release the trigger in neutral position to slow down your model.
3. Pull the trigger forward to brake your model.
For reverse, after stopping the model, release the trigger to neutral position then pull the trigger forward again to
activate reverse.
MOVE YOUR MODEL
FULL THROTTLE NEUTRAL BRAKE/REVERSE
The transmitter and receiver are already paired at the factory and you do not have to do anything. If you wish to connect
the receiver with another transmitter or connect a new receiver, or if you have a problem with the link, follow the steps
below to re-pair.
Start with the radio in the OFF
position
Turn ON the controller switch to
power the receiver.
The LED is now lit solid.
The binding is complete.
The LED flashes
Release the FN button.
A: Press and hold the FN button.
B: Switch ON the transmitter
OPERATE YOUR MODEL
BINDING / LINKING THE RECEIVER AND TRANSMITTER
To Next Page
Loading...